Servo Drives

Servo Drives

Servo drives provide power to a servo motor. A drive can be nothing more than an amplifier, it can be a positioning drive, or it can also include a full-featured motion controller

ABB ACSM1
abb-servo-driveThe M1 drive is available in two variants. The “AS” version is a speed and torque variant that takes an analog speed or torque reference from a traditional motion controller. The “AM” version is programmable, positioning drive capable of electronic gearing and camming.

  • 230VAC models from 3A to 93A
  • 480VAC models from 2.7A to 580A
  • Built-in Safe Torque Off(SIL 3)
  • Many fieldbus options available(CANopen, DeviceNet, Modbus RTU, Modbus/TCP, ProfibusDP, Ethernet/IP, EtherCAT, Sercos II, and Delta Tau’s MACRO


ABB MicroFlex e150
MicroFlex-motion-driveThe MicroFlex e150 is a fully programmable motion drive. This is an excellent drive for lower power applications. Can be used as a stand-alone controller, programmed with the advanced Mint language, or can be used as a slave drive to a motion controller.

  • 120VAC and 230 VAC single-phase models
  • 230 VAC three-phase models
  • Built-in Safe Torque Off(SIL 3)
  • Universal encoder motor feedback(incremental, SinCos, SSI, BiSS, EnDat)
  • Embedded Ethernet provides EtherCAT, Ethernet/IP, ModbusTCP, and Raw Ethernet
  • USB and serial communications standard


ABB MicroFlex Analog
MicroFlex-Analog-servo-driveThe MicroFlex Analog is an analog or step and direction drive. This is an excellent drive for lower power applications.

  • 120VAC and 230 VAC single-phase models
  • 230 VAC three-phase models
  • Encoder, resolver, or SSI motor feedback
  • RS-232 serial communications standard, RS-485 optional


GEFRAN XVy
gefran-xvy-driveThe XVy is a proven design that has some advanced capabilities. Can be used as an speed/torque analog amplifier, or can be programmed to be a stand-alone positioning drive.

  • 230VAC to 480VAC three-phase input
  • Electronic Line Shaft over copper cable or fiber optic cable
  • IEC 61131-3 programmable
  • Optional firmware to run an induction motor for positioning applications
  • Incremental encoder, absolute encoder, and resolver interface is standard


GEFRAN ADV200
gefran-adv-200The ADV200 uses newer technology to provide high performance at a lower cost. Can be used as a speed/torque analog amplifier, or can be programmed to be a stand-alone positioning drive.

  • 480VAC three-phase input
  • Electronic Line Shaft over copper cable or fiber optic cable
  • IEC 61131-3 programmable
  • Incremental encoder interface is standard
  • Profibus, EtherCAT, Ethernet/IP, CANopen, and DeviceNet fieldbus available